Rohde & Schwarz R&S ZNB - Page 482

GUI Reference
R&S
®
ZNB/ZNBT
482User Manual 1173.9163.02 ─ 53
Controls in the Calibration Kits Dialog
Connector Type
The "Connector Type" table displays the available cal kit connector types. Select a row
in this table to get the list of Available Cal Kits.
Remote command:
[SENSe<Ch>:]CORRection:CONNection:CATalog?
Available Cal Kits
Displays the cal kits for the selected Connector Type
Remote command:
[SENSe:]CORRection:CKIT:CATalog?
Add / Copy / Delete / Standards...
The buttons in the right part of the dialog are used to manage calibration kits:
●
"Add" creates a cal kit file for the selected connector type.
●
"Copy" creates a cal kit file based on the contents of an existing cal kit file.
●
"Delete" deletes an imported or user-defined cal kit file.
●
"Standards..." opens the "Kit Standards" dialog, which shows the contents of the
cal kit file. For user-defined or imported kits, you can modify the contents. See "Kit
Standards Dialog" on page 483.
Remote command:
The following commands create and modify calibration kits:
[SENSe:]CORRection:CKIT:<ConnType>:SELect
[SENSe:]CORRection:CKIT:<ConnType>:LSELect
[SENSe:]CORRection:CKIT:DMODe
[SENSe:]CORRection:CKIT:DELete
Query connector types and calibration kits:
Cal Softtool