Rohde & Schwarz R&S ZNB - Display Softtool; Diagram Tab

GUI Reference
R&S
®
ZNB/ZNBT
656User Manual 1173.9163.02 ─ 53
Embedded LO
Select "Embedded LO" if in the related mixer measurement the LO cannot be provided
by the VNA or a connected external generator. Setting this flag makes the LO drive
power range read-only.
Use Fixed Freq
Uncheck "Use Fixed Freq" if you want the LO signal to vary in frequency, which will
enable "LO Freq Min" and "LO Freq Max". Otherwise only "LO Fixed Freq" is enabled.
6.16 Display Softtool
The "Display" softtool provides all display settings and the functions for activating,
modifying and arranging different diagrams.
Access: SYSTEM – [DISPLAY]
Related information
Refer to the following sections:
●
Chapter 5.1.3, "Traces, Channels and Diagrams", on page 81
●
Chapter 5.2.1, "Display Elements of a Diagram", on page 92
●
Chapter 4.3.4, "Handling Diagrams, Traces, and Markers", on page 58
6.16.1 Diagram Tab
Selects a diagram as the active diagram, defines a title, deletes or adds diagrams and
arranges them on the screen. Many of the functions are unavailable if the active recall
set contains only one diagram.
Related settings
Use the icons in the toolbar to add diagrams and traces. Use the "Zoom Active Trc"
icon to zoom into a rectangular portion inside a diagram. See also Chapter 4.3.4, "Han-
dling Diagrams, Traces, and Markers", on page 58 and Chapter 4.3.6.1, "Using the
Graphical Zoom", on page 66.
Display Softtool