GUI Reference
R&S
®
ZNB/ZNBT
684User Manual 1173.9163.02 ─ 53
Common Controls in the Info Dialog
The "Save...", "Print... ", and "Save Report" buttons at the bottom of the "Info" dialog
allow you to save the contents of the open tab to a file or to create a hardcopy.
Save... / Print... / Save Report
●
"Save..." allows you to save the contents of the open tab to a file.
●
"Print... " allows you to print the contents of the open tab.
●
"Save Report" saves the current selftest results to a zipped report file you can send
in for fault diagnosis; see Chapter 10.3, "Collecting Information for Technical Sup-
port", on page 1377.
Remote command:
DIAGnostic:DEVice:STATe
SYSTem:DFPRint?
Setup Tab
Displays the channel and trace settings of the active recall set and the main character-
istics of the instrument, including its IP address.
Options Tab
Shows the installed software and hardware options. You can also enable additional
software options using the option key supplied with the option. Proceed according to
the instructions in the dialog.
For an overview of options, refer to Chapter 5.7, "Optional Extensions and Accesso-
ries", on page 202.
Setup Softtool
To Next Page
Loading...
