Command Reference
R&S
®
ZNB/ZNBT
797User Manual 1173.9163.02 ─ 53
Parameters:
<String> Path to the Touchstone file, either absolute or relative to the cur-
rent directory (see MMEMory:CDIRectory)
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset " on page 585
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure:SHORt
For a fixture modeling with the ISD tool and coupon type OPSHort1x (see
CALCulate:FMODel:ISD<Ph_pt>:COUPon:TYPE), this command starts the mea-
surement of the Short coupon at the active ports (see CALCulate:FMODel:
ISD<Ph_pt>:COUPon[:STATe]).
Suffix:
<Ph_pt>
.
This suffix is ignored.
Usage: Event
Manual operation: See "Measure / Measure Open / Measure Short" on page 585
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure:SHORt:FILename <String>
For a fixture modeling with the ISD tool and coupon type OPSHort1x (see
CALCulate:FMODel:ISD<Ph_pt>:COUPon:TYPE), this command loads the proper-
ties of the Short coupon from a Touchstone file.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<String> Path to the Touchstone file, either absolute or relative to the cur-
rent directory (see MMEMory:CDIRectory)
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset " on page 585
CALCulate:FMODel:ISD<Ph_pt>:COUPon:TYPE <CouponType>
Sets/gets the coupon type to be measured for a fixture modeling with the ISD tool.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<CouponType> SYMMetric2x | OPEN1x | SHORt1x | OPSHort1x
Example: See Chapter 9.2.8, "Fixture Modeling", on page 1371
Manual operation: See "Coupon Type" on page 585
CALCulate:FMODel:ISD<Ph_pt>:COUPon[:STATe] <Boolean>
For a fixture modeling with the ISD tool, this command allows to specify the ports to
which the test coupon is connected.
SCPI Command Reference
To Next Page
Loading...
