Rohde & Schwarz R&S ZNB - Page 802

Command Reference
R&S
®
ZNB/ZNBT
802User Manual 1173.9163.02 ─ 53
successfully loaded from file (using CALCulate:FMODel:ISD<Ph_pt>:COUPon:
MEASure:FILename
●
the measurement of DUT + test fixture (using CALCulate:FMODel:
ISD<Ph_pt>:DUT:MEASure) finished successfully
The resulting Touchstone files are written to C:\Users\Public\Documents\Rohde-
Schwarz\Vna\Embedding. If result files with the same name already exist, they will be
overwritten.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Example: See Chapter 9.2.8, "Fixture Modeling", on page 1371
Usage: Event
Manual operation: See "Run <Fixture Modeling Tool>" on page 587
CALCulate:FMODel:ISD<Ph_pt>:RUN[:STATe] <Boolean>
For a fixture modeling with the ISD tool, this command allows to specify the ports to
which the deembedding files shall be assigned after the tool has run.
Suffix:
<Ph_pt>
.
Physical port number for single-ended deembedding, logical port
number for balanced deembedding.
Parameters:
<Boolean> 1 (ON) if a deembedding file shall be assinged to port <Pt>, 0
(OFF) otherwise
Example: See Chapter 9.2.8, "Fixture Modeling", on page 1371
Manual operation: See "Apply" on page 588
CALCulate:FMODel:ISD<Ph_pt>:SCALe:ATTenuation <AttenLeadInScaling>
Scales the test coupon’s attenuation (dB).
Sets/gets the atten_scale 1 batch mode parameter of the ISD tool
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<AttenLeadInScaling>
Manual operation: See "Scaling for Lead In Atten" on page 589
CALCulate:FMODel:ISD<Ph_pt>:SCALe:FREQuency <MaxFrequency>
Defines the maximum frequency to deembed.
Corresponds to the max_frequency batch mode parameter of the ISD tool.
SCPI Command Reference