Rohde & Schwarz R&S ZNB - Page 803

Command Reference
R&S
®
ZNB/ZNBT
803User Manual 1173.9163.02 ─ 53
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<MaxFrequency> Default unit: Hz
Manual operation: See "Max Freq to Deembed" on page 591
CALCulate:FMODel:ISD<Ph_pt>:SCALe:FTIMe <FltLeadInScalingTime>
Overrides the lead-in’s flight time in case the through-trace test coupon is a bit too
short or too long.
Sets/gets the atten_scale 1 batch mode parameter of the ISD tool.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<FltLeadInScalingTime>
Manual operation: See "Scaling for Flt Tm" on page 589
CALCulate:FMODel:ISD<Ph_pt>:TRACe:COUPling <TraceCoupling>
Tells the ISD tool about coupling among lead-in traces.
Corresponds to the coupling batch mode parameter of the ISD tool.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<TraceCoupling> NONE | WEAK | STRong
NONE: no coupling.
WEAK: coupling will be extracted even if there are 2 ports
enabled on the test coupon
STRong: if the test coupon is a 4-port file, and there are two
ports to be extracted, the ISD tool will optimize odd- and even-
mode insertion losses
Manual operation: See "Trace Coupling" on page 591
CALCulate:FMODel:REName <Boolean>
If set to ON (1), the names of subsequently generated "Test Coupon" and "DUT + Test
Fixture" files are prefixed with the current date and time.
Parameters:
<Boolean>
Manual operation: See "Timestamp Filenames" on page 584
SCPI Command Reference