GUI Reference
R&S
®
ZNB/ZNBT
588User Manual 1173.9163.02 ─ 53
Note:
●
If there are any errors in running the fixture deembedding tool, an error log of the
tool is automatically presented in the default text editor (e.g., Notepad).
●
For ISD first a batch task file config_znb.abt is created and then the tool is run
in batch mode (see the ISD User Guide)
Remote command:
CALCulate:FMODel:ISD<Ph_pt>:RUN:RUN
CALCulate:FMODel:SFD<Ph_pt>:RUN:RUN
Abort Run
During the Run <Fixture Modeling Tool> step, the user may abort the tool execution at
any time.
Remote command:
n.a.
Apply
Use these checkboxes to indicate the ports (physical for single-ended deembedding,
logical for balanced deembedding) to which the deembedding files (generated by Run
<Fixture Modeling Tool>) shall be assigned when the dialog is closed using Apply.
Note: For a "left" deembedding file the original port order is used, for a "right" de-
embedding files the swap gates (ports) function is used.
Remote command:
CALCulate:FMODel:ISD<Ph_pt>:RUN[:STATe]
CALCulate:FMODel:SFD<Ph_pt>:RUN[:STATe]
Display
Select "Display" to display some or all the S parameter traces of the generated touch-
stone file that are applied for deembedding. A dialog then allows you to select the S
parameter traces to be imported to new memory traces:
6.13.5.5 ISD Advanced Settings
For details see the ISD User Guide.
Offset Embed Softtool
To Next Page
Loading...
