Trace Menu R&S
®
ZVA/ZVB/ZVT
1145.1084.12 4.44 E-6
• Next Trace selects the next trace as the active trace (disabled if only one trace is defined).
• Select Trace opens a box to select an arbitrary trace of the active setup as the active trace
(disabled if only one trace is defined).
• Add Trace creates a new trace in the current diagram area.
• Add Trace + Diag. Area generates a new trace in a new diagram area.
• Delete Trace deletes the active trace.
• Assign Channel assigns the active trace to another channel.
• Assign Diag. Area assigns the active trace to another diagram area.
• Trace Manager opens a dialog to perform the previous actions systematically for all traces and
diagram areas.
Active and inactive traces
The screen can display several diagram areas simultaneously, each with a variable number of traces.
• In an active diagram area one of these traces is the active trace. The active trace is highlighted
in the trace list on top of the diagram area (Trc 3 in the figure below):
• If an inactive area is selected as the active area, the trace that was active last time when the
area was active will again become the active trace. It is highlighted in the trace list of the
inactive diagram area as shown for Trc6 in the figure below:
All settings in the Trace menu except the Trace Functions involving a memory trace apply to the active
trace in the active diagram area.
To Next Page
Loading...
