Rohde & Schwarz R&S ZVA 8 - Page 310

Channel Menu R&S
®
ZVA/ZVB/ZVT
1145.1084.12 4.148 E-6
To continue, click OK and select any other trigger or sweep type (e.g. CW Mode).
Remote control:
TRIGger[:SEQuence]:SOURce TIMer
TRIGger[:SEQuence]:TIMer
Manual Trigger
In Manual trigger mode the trigger signal is generated on pressing the Manual Trigger
softkey. Manual Trigger is disabled unless manual trigger mode is active.
Remote control:
TRIGger[:SEQuence]:SOURce MANual
*TRG
Trigger Settings
Trigger Settings opens a dialog to specify the operation that the analyzer carries out after receiving a
trigger event.
The dialog is divided into the following panels (for a detailed description refer to the following sections):
• Triggered Meas. Sequence selects the measurement cycle or sequence of actions to be
triggered.
• Trigger Delay specifies a delay time between the trigger event and the start of the
measurement.
The Trigger Settings are valid for all trigger modes except Free Run. Some trigger settings are
incompatible with other measurement settings; see below.