R&S
®
ZVA/ZVB/ZVT Channel Menu
1145.1084.12 4.177 E-6
The diagram contains the mixer signal diagram and the following control elements:
•
The RF Power radio button groups specify how the power for each signal is defined. The roles
of the mixer input signals RF and LO are interchangeable: One signal is at the analyzer's
channel power (Sweep or CW, the signal is swept if a power sweep is active; it is at fixed power
(CW) for the other sweep types), the other is at the Fixed power defined below.
• The input fields in the Sweep/CW Power panel define the channel power and overwrite the
power settings in the Channel – Stimulus and Channel – Power Bandwidth Average menus.
The sweep range or CW power is assigned to the signal with Sweep/CW power definition.
• Fixed Power defines the power to be assigned to the signal with Fixed power definition.
Remote control:
SOURce<Ch>:]FREQuency:CONVersion:MIXer:FUNDamental RF | LO
SOURce<Ch>:]FREQuency:CONVersion:MIXer:PFIXed <power>
Set Frequencies
Controls the frequency of the RF and the LO signal and the analyzer (IF signal) frequency.
The diagram contains the mixer signal diagram and the following control elements:
• The ...Frequency radio button groups specify how the frequency for each signal is defined. The
roles of the three signals RF, IF, LO are interchangeable: One signal is at the analyzer's
channel frequency (Swept/CW, the signal is swept if a frequency sweep type is active; it is a
CW signal for the other sweep types), the second is at the Fixed frequency defined below, the
frequency of the third signal is calculated according to the selected Conversion formula.
• The input fields in the Swept Frequency panel define the channel frequency and overwrite the
Channel – Stimulus settings. The sweep range or CW frequency is assigned to the signal with
Swept/CW frequency definition.
To Next Page
Loading...
