R&S
®
ZVA/ZVB/ZVT Channel Menu
1145.1084.12 4.223 E-6
In the dialog, it is possible to select one of the calibration kits in use (Kit Name) and select either all or a
single standard to be copied. A calibration kit may only contain a single standard of each type.
Select Calibration Kit to View / Modify
Displays a list of calibration kits to be modified. This dialog is opened from the Calibration Kits dialog
(View / Modify Kit... button).
The table shows the calibration kits with their name, connector type and label (if defined). OK opens the
View / Modify Calibration Kit dialog for the selected kit.
Predefined calibration kits are displayed in the Select Calibration Kit to View / Modify dialog so
that it is possible to check the parameters and properties of their standards.
Select Cal Kit to Delete
Displays a list of calibration kits to be deleted. This dialog is opened from the Calibration Kits dialog
(Delete Kits... button).
To Next Page
Loading...
