R&S
®
ZVA/ZVB/ZVT System Menu
1145.1084.12 4.255 E-6
The External Power Meters dialog provides two tables and some additional buttons.
• The upper table (Found:) shows all power meters that the analyzer detects to be on line (i.e.
connected and switched on). All power meters in the table must have been configured
previously, however, they can be deleted in the lower table.
• Add v and Add All v buttons copy the selected power meter in the upper table to the lower table
so that it is possible to modify the power meter settings and select the power meters as
receivers for measurements and power calibrations.
• If Auto Config NRP-Zxx is selected, the analyzer automatically configures the first power meter
detected at one of the USB ports as Pmtr 1. To detect several connected NRP-Zxx power
meters and/or add an NRP-Zxx to the lower table, the automatic configuration must be disabled
(no risk of arbitrary assignment of power meter numbers).
• The lower table (Configured:) shows all configured power meters with their properties. The
properties are defined in the Add/Modify External Power Meter dialog, to be opened by means
of the Add Other... or Modify... buttons. All configured power meters are available as additional
receivers for measurements and power calibrations.
An icon in the first columns of the tables indicates whether the power meters are currently available.
The Found: table and the icons in the Configured: table are automatically updated each time the
External Generators dialog is opened (to update explicitly use the Refresh button). The remaining
control elements are self-explanatory.
Remote control:
SYSTem:COMMunicate:RDEVice:PMETer<pmet_no>:DEFine
SYSTem:COMMunicate:RDEVice:PMETer<pmet_no>:DELete
To Next Page
Loading...
