Rohde & Schwarz R&S ZVA 8 - Page 768

Program Examples R&S
®
ZVA/ZVB/ZVT
1145.1084.12 7.2 E-1
//
// Select active traces for the new created channels 1 - 4
:CALCulate1:PARameter:SELect 'Trc1'
:CALCulate2:PARameter:SELect 'Trc2'
:CALCulate3:PARameter:SELect 'Trc3'
:CALCulate4:PARameter:SELect 'Trc4'
//
// Create diagrams 1 - 4
:DISPlay:WINDow1:STATe ON
:DISPlay:WINDow2:STATe ON
:DISPlay:WINDow3:STATe ON
:DISPlay:WINDow4:STATe ON
//
// Assign trace 'Trc1' - 'Trc4' to a window = diagram area 1 - 4
:DISPlay:WINDow1:TRACe1:FEED 'Trc1'
:DISPlay:WINDow2:TRACe1:FEED 'Trc2'
:DISPlay:WINDow3:TRACe1:FEED 'Trc3'
:DISPlay:WINDow4:TRACe1:FEED 'Trc4'
//
// Query trace names assigned to window trace
:DISPlay:WINDow1:TRACe1:FEED?
:DISPlay:WINDow2:TRACe1:FEED?
:DISPlay:WINDow3:TRACe1:FEED?
:DISPlay:WINDow4:TRACe1:FEED?
Calibration
The following example shows you how to perform a multiport calibration of the analyzer.
// Reset the analyzer
*RST
//
// Set cal kit as active kit for N50
:SENSE:CORRECTION:CKIT:N50:SELECT 'N 50 Ohm Dummy Kit'
//
// Select connectors for the ports
:SENSE1:CORRECTION:COLLECT:CONNECTION1 N50MALE
:SENSE1:CORRECTION:COLLECT:CONNECTION2 N50MALE
//