Rohde & Schwarz RTB2000 Series - Vertikale Einstellungen

Fernsteuerbefehle
R&S
®
RTB2000
277Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<NSingleCount> Number of waveforms.
Bereich: 1 to maximum number that depends on the record
length.
*RST: 1
STOP
Stops the running acquistion.
Verwendung: Ereignis
Asynchroner Befehl
ACQuire:STATe
Sets or queries the acquisition state of the instrument.
Parameter:
<AcquisitionState> RUN | STOPping | COMPlete | BREak
RUN | STOP | COMPlete | BREak
RUN
Set: Starts the acquisition.
Read: The acquisition is running.
STOPping
Set: Stops the acquisition when it is finished.
Read: Acquisition is stopped.
COMPlete
Set: Not available.
Read: The current acquisition is finished and completed.
BREak
Set: Immediate interrupt of current acquisition.
Read: acquisition is finished but interrupted.
15.4.3 Vertikale Einstellungen
CHANnel<m>:STATe...................................................................................................... 278
CHANnel<m>:AON........................................................................................................ 278
CHANnel<m>:AOFF.......................................................................................................278
CHANnel<m>:SCALe..................................................................................................... 278
CHANnel<m>:RANGe.................................................................................................... 279
CHANnel<m>:OFFSet....................................................................................................279
CHANnel<m>:COUPling.................................................................................................279
CHANnel<m>:BANDwidth...............................................................................................280
CHANnel<m>:POLarity...................................................................................................280
CHANnel<m>:SKEW......................................................................................................280
CHANnel<m>:ZOFFset[:VALue]...................................................................................... 281
CHANnel<m>:WCOLor...................................................................................................281
Grundeinstellungen