Fernsteuerbefehle
R&S
®
RTB2000
286Bedienhandbuch 1333.1611.03 ─ 05
15.4.6 Erfassungseinstellungen
ACQuire:POINts:AUTomatic............................................................................................286
ACQuire:POINts[:VALue]................................................................................................ 286
CHANnel<m>:TYPE.......................................................................................................287
ACQuire:TYPE.............................................................................................................. 287
CHANnel<m>:ARIThmetics.............................................................................................288
ACQuire:PEAKdetect..................................................................................................... 288
ACQuire:HRESolution.................................................................................................... 288
ACQuire:NSINgle:COUNt................................................................................................289
ACQuire:AVERage:COUNt..............................................................................................289
ACQuire:AVERage:RESet...............................................................................................289
ACQuire:AVERage:COMPlete?....................................................................................... 289
TIMebase:ROLL:AUTomatic............................................................................................289
TIMebase:ROLL:MTIMe..................................................................................................290
ACQuire:INTerpolate...................................................................................................... 290
ACQuire:POINts:ARATe?................................................................................................290
ACQuire:SRATe?........................................................................................................... 290
ACQuire:POINts:AUTomatic <AutoRecordLength>
Enables or disables the automatic record length. The instrument sets a value that fits
to the selected timebase.
If you set a specific value with ACQuire:POINts[:VALue], the automatic assign-
ment of a record length is turned off.
Parameter:
<AutoRecordLength> ON | OFF
Beispiel:
ACQ:POIN:AUT ON
TIM:SCAL 1e-9
ACQ:POIN?;:SYST:ERR:ALL?
-> received 10000;0,"No error"
TIM:SCAL 5e-3
ACQ:POIN?;:SYST:ERR:ALL?
-> received 20000000;0,"No error"
ACQuire:POINts[:VALue]
Defines a record length value, the number of recorded waveform points in a segment.
The command turns ACQuire:POINts:AUTomatic OFF.
If ACQuire:POINts:AUTomatic is turned ON, the query ACQuire:POINts? returns
the automatically set record length.
Each predefined record length corresponds to a maximum number of history seg-
ments, which are stored in the instrument's memory. If option R&S RTB-K15 is instal-
led, you can display the history segments.
Grundeinstellungen
To Next Page
Loading...
