Rohde & Schwarz RTB2000 Series - Page 327

Fernsteuerbefehle
R&S
®
RTB2000
327Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<PlayAll> ON | OFF
If set to OFF, define the range of segments to be shown using
CHANnel<m>:HISTory:STARt and CHANnel<m>:HISTory:
STOP
*RST: ON
BUS<b>:HISTory:STARt <StartAcquisition>
DIGital<m>:HISTory:STARt <StartAcquisition>
LOGic<p>:HISTory:STARt <StartAcquisition>
SPECtrum:HISTory:STARt <StartAcquisition>
CHANnel<m>:HISTory:STARt <StartAcquisition>
Sets the index of the oldest segment to be displayed.
Parameter:
<StartAcquisition> Start index. You can enter a positive or negative index, see
CHANnel<m>:HISTory:CURRent .
BUS<b>:HISTory:STOP <StopAcquisition>
DIGital<m>:HISTory:STOP <StopAcquisition>
LOGic<p>:HISTory:STOP <StopAcquisition>
SPECtrum:HISTory:STOP <StopAcquisition>
CHANnel<m>:HISTory:STOP <StopAcquisition>
Sets the index of the latest segment to be displayed.
Parameter:
<StopAcquisition> Stop index. You can enter a positive or negative index, see
CHANnel<m>:HISTory:CURRent.
BUS<b>:HISTory:PLAYer:SPEed <PlayerSpeed>
DIGital<m>:HISTory:PLAYer:SPEed <PlayerSpeed>
LOGic<p>:HISTory:PLAYer:SPEed <PlayerSpeed>
SPECtrum:HISTory:PLAYer:SPEed <PlayerSpeed>
CHANnel<m>:HISTory:PLAYer:SPEed <PlayerSpeed>
Sets the speed of the history replay.
Parameter:
<PlayerSpeed> SLOW | MEDium | FAST | AUTO
*RST: AUTO
BUS<b>:HISTory:REPLay <Replay>
DIGital<m>:HISTory:REPLay <Replay>
LOGic<p>:HISTory:REPLay <Replay>
Messkurvenanalyse