Rohde & Schwarz RTB2000 Series - Page 338

Fernsteuerbefehle
R&S
®
RTB2000
338Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<SignalSource> CH1..4 | MA1 | RE1..4 | D0..15
Waveform to be measured, required for all measurement types.
For delay and phase measurements, it is the „Messquelle“ (Mea-
sure Source).
CH1 | CH2 | CH3 | CH4
Active signal channels 1 to 4
MA1
Active math channel
RE1 | RE2 | RE3 | RE4
Active reference channels 1 to 4
D0..D15
Active digital channels D0...D15. Only available, if MSO option
R&S RTB-B1 is installed.
<SignalSource2>
None | CH1..4 | MA1 | RE1..4 | D0..15
Second waveform, reference source that is required for delay
and phase mesurements („Messquelle 2“ (Measure Source 2)).
MEASurement<m>:DELay:SLOPe <SignalSlope>,<ReferenceSlope>
Sets the edges to be used for delay measurement. The associated waveforms are defi-
ned with MEASurement<m>:SOURce.
Parameter:
<SignalSlope> POSitive | NEGative
Slope of first waveform („Messquelle“ (Measure Source)).
*RST: POS
<ReferenceSlope> POSitive | NEGative
Slope of the reference waveform („Messquelle 2“ (Measure
Source 2)).
*RST: POS
MEASurement<m>:STATistics[:ENABle] <StatisticEnable>
Activates or deactivates the statistical evaluation for all active measurements.
Suffix:
<m>
.
1..4
The suffix is irrelevant.
Parameter:
<StatisticEnable> ON | OFF
*RST: OFF
Messungen