Rohde & Schwarz RTB2000 Series - Page 339

Fernsteuerbefehle
R&S
®
RTB2000
339Bedienhandbuch 1333.1611.03 ─ 05
MEASurement<m>:STATistics:RESet
Deletes the statistical results for all measurements, and starts a new statistical evalua-
tion if the acquisition is running. The waveform count is set to 0 and all measurement
values are set to NAN.
Suffix:
<m>
.
1..4
The suffix is irrelevant.
Verwendung: Ereignis
15.7.2.2 Messergebnisse
Sie können die statistischen Ergebnisse mit den MEAS:STAT-Befehlen abfragen.
Exportieren Sie statistische Ergebnisse mit den EXP:MEAS:STAT-Befehlen in eine
CSV-Datei. Statistiken können nur bei Fernbedienung exportiert werden, nicht bei
Handbedienung.
MEASurement<m>:RESult[:ACTual]?...............................................................................339
MEASurement<m>:RESult:AVG?.................................................................................... 340
MEASurement<m>:RESult:STDDev?...............................................................................340
MEASurement<m>:RESult:NPEak?.................................................................................340
MEASurement<m>:RESult:PPEak?................................................................................. 340
MEASurement<m>:RESult:WFMCount?...........................................................................341
MEASurement<m>:STATistics:WEIGht.............................................................................341
MEASurement<m>:STATistics:VALue:ALL?...................................................................... 341
MEASurement<m>:STATistics:VALue<n>?....................................................................... 342
EXPort:MEASurement<m>:STATistics:NAME....................................................................342
EXPort:MEASurement<m>:STATistics:SAVE.................................................................... 342
EXPort:MEASurement:STATistics:ALL:NAME................................................................... 342
EXPort:MEASurement:STATistics:ALL:SAVE.................................................................... 343
MEASurement<m>:RESult[:ACTual]? [<MeasType>]
Returns the result of the specified measurement type.
Suffix:
<m>
.
1..4
Selects the measurement place.
Abfrageparameter:
<MeasType> FREQuency | PERiod | PEAK | UPEakvalue | LPEakvalue |
PPCount | NPCount | RECount | FECount | HIGH | LOW |
AMPLitude | MEAN | RMS | RTIMe | FTIMe | PDCYcle |
NDCYcle | PPWidth | NPWidth | CYCMean | CYCRms |
STDDev | CYCStddev | DELay | PHASe | BWIDth |
POVershoot | NOVershoot
Specifies the measurement type, see MEASurement<m>:MAIN
auf Seite 335. If you omit the parameter, the result of the last
measurement setup is returned.
Messungen