Rohde & Schwarz RTB2000 Series - Page 349

Fernsteuerbefehle
R&S
®
RTB2000
349Bedienhandbuch 1333.1611.03 ─ 05
CURSor<m>:Y1Position <Yposition1>
CURSor<m>:Y2Position <Yposition2>
The commands specify or return the positions of horizontal cursor lines on the y-axis
(voltage, current, level for FFT).
Suffix:
<m>
.
1, the suffix is irrelevant.
Parameter:
<Yposition2> Bereich: Depends on the current instrument settings.
Inkrement: 0.01
Std.-einheit: V
CURSor<m>:YCOupling
<Coupling>
CURSor<m>:XCOupling <Coupling>
If enabled, the cursor lines are coupled so that the distance between the two lines
remains the same if one cursor is moved.
Suffix:
<m>
.
1, the suffix is irrelevant.
Parameter:
<Coupling> ON | OFF
*RST: OFF
CURSor<m>:SWAVe
Autoset for cursor lines, sets the cursor lines to typical points of the waveform depen-
ding on the selected cursor type. For example, for voltage measurement („Horizontal“),
the cursor lines are set to the upper and lower peaks of the waveform. For time measu-
rement („Vertical“), the cursor lines are set to the edges of two consecutive positive or
two consecutive negative pulses.
Suffix:
<m>
.
1, the suffix is irrelevant.
Verwendung: Ereignis
CURSor<m>:SSCReen
Resets the cursors to their initial positions. This is helpful if the cursors have disappea-
red from the display or need to be moved for a larger distance.
Suffix:
<m>
.
1, the suffix is irrelevant.
Verwendung: Ereignis
Messungen