Rohde & Schwarz RTB2000 Series - Page 354

Fernsteuerbefehle
R&S
®
RTB2000
354Bedienhandbuch 1333.1611.03 ─ 05
Verwendung: Nur Einstellung
MASK:LOAD <Filename>
Loads a stored mask from the specified file.
Einstellparameter:
<Filename> String parameter
Path and file name
Verwendung: Nur Einstellung
15.8.1.2
Aktionen bei Verletzung
MASK:ACTion:SOUNd:EVENt:MODE.............................................................................. 354
MASK:ACTion:STOP:EVENt:MODE.................................................................................354
MASK:ACTion:SCRSave:EVENt:MODE........................................................................... 354
MASK:ACTion:WFMSave:EVENt:MODE.......................................................................... 354
MASK:ACTion:PULSe:EVENt:MODE............................................................................... 354
MASK:ACTion:STOP:EVENt:COUNt................................................................................355
MASK:ACTion:SCRSave:DESTination............................................................................. 355
MASK:ACTion:WFMSave:DESTination.............................................................................355
MASK:ACTion:YOUT:ENABle..........................................................................................355
MASK:ACTion:SOUNd:EVENt:MODE <EventMode>
MASK:ACTion:STOP:EVENt:MODE <EventMode>
MASK:ACTion:SCRSave:EVENt:MODE <EventMode>
MASK:ACTion:WFMSave:EVENt:MODE <EventMode>
MASK:ACTion:PULSe:EVENt:MODE <EventMode>
Defines when and how often the action is executed.
●
SOUNd: Generates a beep sound on mask violation.
●
STOP: Stops the waveform acquisition, after mask is violated for a defined number
of times. You can set how many times with the command MASK:ACTion:STOP:
EVENt:COUNt.
●
PULSe: Creates a pulse on the [Aux Out] connector. This selection sets the confi-
guration of the [Aux Out] connector to „Maskenverletzung“ (Mask Violation).
●
SCRSave: Saves a screenshot on mask violation. To set path and filename of the
screenshot, use MASK:ACTion:SCRSave:DESTination.
●
WFMSave: Saves the waveform data on mask violation. To set path and filename
of the data file, use MASK:ACTion:WFMSave:DESTination.
Anwendungen