Rohde & Schwarz RTB2000 Series - Page 355

Fernsteuerbefehle
R&S
®
RTB2000
355Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<EventMode> OFF | EACH
OFF
No action is executed.
EACH
The selected action is executed on each violation of the mask.
*RST: OFF
MASK:ACTion:STOP:EVENt:COUNt <EventCount>
Sets the number of mask violations after which the action is executed.
Parameter:
<EventCount> Integer value, number of the violations that executes the action.
MASK:ACTion:SCRSave:DESTination
<File>
Defines the path and filename for a screenshot that will be saved on mask violation.
The file format is PNG, the filename is incremented automatically.
Parameter:
<File> String parameter
Beispiel:
MASK:ACT:SCRS:DEST "/USB_FRONT/MASKS/VIOL"
On first violation, the screeenshot is saved to VIOL.PNG, on
second violation to VIOL01.PNG, the third to VIOL02.PNG ...
MASK:ACTion:WFMSave:DESTination <File>
Defines the path and filename for a waveform data that will be saved on mask viola-
tion. The file format is CSV, the filename is incremented automatically
You can also change the storage location, file name and/or file format manually in the
„Datei“ (File) > „Kurven“ (Waveforms) menu. Remote control uses the recent settings.
Parameter:
<File> String parameter
Beispiel:
MASK:ACT:WFMS:DEST "/USB_FRONT/MASKS/VIOL"
On first violation, the waveform data is saved to VIOL.CSV, on
second violation to VIOL01.CSV, the third to VIOL02.CSV ...
MASK:ACTion:YOUT:ENABle <Yout>
Creates a pulse on the [Aux Out] connector if the mask is violated. This selection sets
the configuration of the [Aux Out] connector to „Maskenverletzung“ (Mask Violation).
Same as MASK:ACTion:PULSe:EVENt:MODE auf Seite 354.
Anwendungen