Rohde & Schwarz RTB2000 Series - Page 359

Fernsteuerbefehle
R&S
®
RTB2000
359Bedienhandbuch 1333.1611.03 ─ 05
SPECtrum:FREQuency:POSition
Defines the vertical position of the spectrum.
Parameter:
<Position> Std.-einheit: div
SPECtrum:FREQuency:SCALe
Sets the vertical scale of the spectrum analysis waveform.
Parameter:
<Scale> Range values and unit depend on SPECtrum:FREQuency:
MAGNitude:SCALe.
15.8.2.2
Frequenzeinstellungen
SPECtrum:FREQuency:CENTer...................................................................................... 359
SPECtrum:FREQuency:FULLspan...................................................................................359
SPECtrum:FREQuency:SPAN.........................................................................................359
SPECtrum:FREQuency:STARt........................................................................................ 360
SPECtrum:FREQuency:STOP.........................................................................................360
SPECtrum:FREQuency:BANDwidth[:RESolution][:VALue]..................................................360
SPECtrum:FREQuency:BANDwidth[:RESolution]:RATio.....................................................360
SPECtrum:FREQuency:CENTer
Defines the position of the displayed frequency domain, which is (Center - Span/2) to
(Center + Span/2). The width of the domain is defined using the command SPECtrum:
FREQuency:SPAN.
Parameter:
<CenterFrequency>
SPECtrum:FREQuency:FULLspan
Performs the spectrum analysis calculation for the full frequency span.
Verwendung:
Ereignis
SPECtrum:FREQuency:SPAN
The span is specified in Hertz and defines the width of the displayed frequency range,
which is (Center - Span/2) to (Center + Span/2).
Parameter:
<Span>
Anwendungen