Rohde & Schwarz RTB2000 Series - Page 366

Fernsteuerbefehle
R&S
®
RTB2000
366Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<Distance>
SPECtrum:MARKer:SETup:EXCursion
Sets a level difference between two subsequent peaks that has to be kept, for the peak
to be detected.
Parameter:
<Excursion>
SPECtrum:MARKer:SETup:MWIDth
Sets the maximum width, that a peak can have for it to be detected.
Parameter:
<MaximumWidth>
SPECtrum:MARKer:REFerence:SETup:CMPeak
Centers the display to the highest detected peak.
Verwendung:
Ereignis
SPECtrum:MARKer:REFerence:SETup:CSCReen
Centers the display to the center frequency.
Verwendung:
Ereignis
15.8.3.3 Referenzmarker
SPECtrum:MARKer:REFerence:SETup:MODE................................................................. 366
SPECtrum:MARKer:REFerence:SETup:INDex..................................................................367
SPECtrum:MARKer:REFerence:SETup:FREQuency......................................................... 367
SPECtrum:MARKer:REFerence:SETup:SPAN.................................................................. 367
SPECtrum:MARKer:RMARker?....................................................................................... 367
SPECtrum:MARKer:RMARker:FREQuency?.....................................................................367
SPECtrum:MARKer:RMARker:LEVel?..............................................................................368
SPECtrum:MARKer:RMODe........................................................................................... 368
SPECtrum:MARKer:REFerence:SETup:MODE
Sets the mode for the selection of the reference peak.
Anwendungen