Rohde & Schwarz RTB2000 Series - Page 406

Fernsteuerbefehle
R&S
®
RTB2000
406Bedienhandbuch 1333.1611.03 ─ 05
SYSTem:COMMunicate:INTerface:ETHernet:IPADdress
SYSTem:COMMunicate:INTerface:ETHernet:SUBNet
SYSTem:COMMunicate:INTerface:ETHernet:GATeway
Return or specify.
●
IP address of the instrument.
●
IP subnet mask used by the instrument.
●
IP gateway used by the instrument.
Parameter:
<FirstByte> Bereich: 0 bis 255
Inkrement: 1
<SecondByte> Bereich: 0 bis 255
Inkrement: 1
<ThirdByte> Bereich: 0 bis 255
Inkrement: 1
<FourthByte> Bereich: 0 bis 255
Inkrement: 1
SYSTem:COMMunicate:INTerface:ETHernet:IPPort <IPPort>
Returns or specifies the IP port number (default = 5025).
Parameter:
<IPPort> Bereich: 1024 bis 65535
SYSTem:COMMunicate:INTerface:ETHernet:HTTPport <HTTPport>
Returns or specifies the VXI-11 port number (default = 1024).
Parameter:
<HTTPport> Bereich: 0 bis 65535
SYSTem:COMMunicate:INTerface:ETHernet:TRANsfer <TransferMode>
Enables automatic transfer speed selection, or selects one of the predefined settings
that corresponds to your network data rate.
Parameter:
<TransferMode> AUTO | FD10 | FD100 | HD10 | HD100
AUTO
Automatic transfer speed
FD10 | FD100 | HD10 | HD100
FD = full duplex, HD = half duplex
10 = 10 Mbps, 100 = 100 Mbps
Allgemeine Geräteeinstellungen