Rohde & Schwarz RTB2000 Series - Analyse Serieller Busse

Fernsteuerbefehle
R&S
®
RTB2000
408Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<OutputMode> OFF | TRIGger | REFerence | MASK | GENerator
OFF
No output
TRIGger
Outputs a pulse when the instrument triggers.
REFerence
Outputs a 10 MHz reference frequency.
MASK
Outputs a pulse when a mask is violated. This function is only
available if a mask is specified.
GENerator
Outputs the waveform specified using the function generator
(requires option R&S RTB-B6)
*RST:
OFF
TRIGger:OUT:PLENgth <PulseLength>
Defines the pulse width of the pulse at the [Aux Out] front connector (at trigger event or
mask viaolation).
Parameter:
<PulseLength> *RST: 1E-6
TRIGger:OUT:POLarity <Polarity>
Defines the polarity of the pulse at the [Aux Out] front connector (at trigger event or
mask viaolation).
Parameter:
<Polarity> POSitive | NEGative
*RST: POS
15.11 Analyse serieller Busse
● Allgemein.............................................................................................................. 409
● SPI (Option R&S RTB-K1).................................................................................... 411
● I²C......................................................................................................................... 423
● UART (Option R&S RTB-K2)................................................................................ 434
● CAN (Option R&S RTB-K3).................................................................................. 443
● LIN (Option R&S RTB-K3).................................................................................... 459
Analyse serieller Busse