Rohde & Schwarz RTB2000 Series - Allgemein

Fernsteuerbefehle
R&S
®
RTB2000
409Bedienhandbuch 1333.1611.03 ─ 05
15.11.1 Allgemein
BUS<b>:TYPE...............................................................................................................409
BUS<b>:STATe..............................................................................................................409
BUS<b>:FORMat...........................................................................................................409
BUS<b>:LABel.............................................................................................................. 409
BUS<b>:LABel:STATe.................................................................................................... 410
BUS<b>:DSIGnals......................................................................................................... 410
BUS<b>:DSIZe..............................................................................................................410
BUS<b>:POSition.......................................................................................................... 410
BUS<b>:RESult............................................................................................................. 411
BUS<b>:TYPE <Type>
Defines the bus or interface type for analysis. All buses require special option to the
instrument.
Suffix:
<b>
.
1 | 2
Parameter:
<Type> PARallel | CPARallel | I2C | SPI | SSPI | UART | CAN | LIN
*RST: PARallel
BUS<b>:STATe <State>
Switches protocol decoding on or off.
Suffix:
<b>
.
1 | 2
Parameter:
<State> ON | OFF
*RST: OFF
BUS<b>:FORMat <Format>
Sets the decoding format for the display on the screen.
Suffix:
<b>
.
1 | 2
Parameter:
<Format> ASCii | HEXadecimal | BINary | DECimal | OCTal
*RST: HEX
BUS<b>:LABel <Label>
Defines an additional name label for the selected bus. The maximum name length is 8
characters, and only ASCII characters provided on the on-screen keypad can be used.
Analyse serieller Busse