Rohde & Schwarz RTB2000 Series - Page 413

Fernsteuerbefehle
R&S
®
RTB2000
413Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<Polarity> POSitive | NEGative
POSitive: rising slope
NEGative: falling slope
*RST: POS
BUS<b>:SPI:DATA:SOURce <Source>
BUS<b>:SPI:MOSI:SOURce <MosiSource>
Selects the input channel of the MOSI / MISO line.
Suffix:
<b>
.
1 | 2
Parameter:
<MosiSource> CH1 | CH2 | CH3 | CH4 | D0..D15
*RST: CH1
BUS<b>:SPI:MISO:SOURce
<MisoSource>
Selects the input channel of the optional MISO line.
Suffix:
<b>
.
1, bus 2 is not available if the MISO source is used.
Parameter:
<MisoSource> CH1 | CH2 | CH3 | CH4 | NONE | D0..D15
*RST: NONE
BUS<b>:SPI:DATA:POLarity <Polarity>
Selects whether transmitted data is high active (high = 1) or low active (low = 1) on the
data line.
Suffix:
<b>
.
1 | 2
Parameter:
<Polarity> POSitive | NEGative
POSitive = high active
NEGative = low active
*RST: POSitive
BUS<b>:SPI:MOSI:POLarity <MosiPolarity>
Selects if transmitted data is high active (high = 1) or low active (low = 1) on the MOSI/
MISO line.
Suffix:
<b>
.
1 | 2
Analyse serieller Busse