Rohde & Schwarz RTB2000 Series - Page 416

Fernsteuerbefehle
R&S
®
RTB2000
416Bedienhandbuch 1333.1611.03 ─ 05
BUS<b>:SSPI:MISO:SOURce <MisoSource>
Selects the input channel of the optional MISO line.
Suffix:
<b>
.
1, bus 2 is not available if the MISO source is used.
Parameter:
<MisoSource> CH1 | CH2 | CH3 | CH4 | NONE | D0..D15
*RST: NONE
BUS<b>:SSPI:DATA:POLarity <Polarity>
Selects whether transmitted data is high active (high = 1) or low active (low = 1) on the
data line.
Suffix:
<b>
.
1 | 2
Parameter:
<Polarity> POSitive | NEGative
POSitive = high active
NEGative = low active
*RST: POSitive
BUS<b>:SSPI:MOSI:POLarity <MosiPolarity>
Selects if transmitted data is high active (high = 1) or low active (low = 1) on the MOSI/
MISO line.
Suffix:
<b>
.
1 | 2
Parameter:
<MosiPolarity> ACTLow | ACTHigh
*RST: ACTH
BUS<b>:SSPI:MISO:POLarity <MisoPolarity>
Selects whether transmitted data is high active (high = 1) or low active (low = 1) on the
MISO line.
Suffix:
<b>
.
1, bus 2 is not available if the MISO source is used.
Parameter:
<MisoPolarity> ACTLow | ACTHigh
*RST: ACTH
Analyse serieller Busse