Rohde & Schwarz RTB2000 Series - Page 437

Fernsteuerbefehle
R&S
®
RTB2000
437Bedienhandbuch 1333.1611.03 ─ 05
15.11.4.2 UART-Trigger
To configure the protocol trigger, make sure to set first:
●
TRIGger:A:TYPE to BUS
●
TRIGger:A:SOURce to SBUS1 | SBUS2
TRIGger:A:SOURce:UART............................................................................................. 437
TRIGger:A:UART:MODE.................................................................................................437
TRIGger:A:UART:PATTern.............................................................................................. 438
TRIGger:A:UART:PLENgth..............................................................................................438
TRIGger:A:UART:POFFset..............................................................................................439
TRIGger:A:SOURce:UART <UartSource>
Selects the transmitter or receiver line as trigger source.
Parameter:
<UartSource> RX | TX
TRIGger:A:UART:MODE <Mode>
Specifies the trigger mode for UART/RS-232 interfaces.
See also: "UART-Triggereinstellungen" auf Seite 210.
Analyse serieller Busse