Rohde & Schwarz RTB2000 Series - Page 445

Fernsteuerbefehle
R&S
®
RTB2000
445Bedienhandbuch 1333.1611.03 ─ 05
BUS<b>:CAN:SAMPlepoint <SamplePoint>
Sets the position of the sample point within the bit in percent of the nominal bit time.
See also: "Abtastpunkt (Sample Point)" auf Seite 217.
Suffix:
<b>
.
1 | 2
Parameter:
<SamplePoint> Bereich: 10 bis 90
Inkrement: 1
*RST: 50
Std.-einheit: %
BUS<b>:CAN:BITRate
<BitRate>
Sets the number of transmitted bits per second.
Suffix:
<b>
.
1 | 2
Parameter:
<BitRate> Bereich: 100 bis 5,04E06
Inkrement: Depends on the bit rate value
*RST: 50E03
Std.-einheit: Bit/s
15.11.5.2 CAN-Trigger
To configure the protocol trigger, make sure to set first:
●
TRIGger:A:TYPE to BUS
●
TRIGger:A:SOURce to SBUS1 | SBUS2
TRIGger:A:CAN:TYPE....................................................................................................445
TRIGger:A:CAN:FTYPe..................................................................................................446
TRIGger:A:CAN:ITYPe................................................................................................... 446
TRIGger:A:CAN:ICONdition............................................................................................ 447
TRIGger:A:CAN:IDENtifier.............................................................................................. 447
TRIGger:A:CAN:DCONdition...........................................................................................447
TRIGger:A:CAN:DLC......................................................................................................447
TRIGger:A:CAN:DATA....................................................................................................448
TRIGger:A:CAN:ACKerror...............................................................................................448
TRIGger:A:CAN:BITSterror............................................................................................. 448
TRIGger:A:CAN:CRCerror.............................................................................................. 448
TRIGger:A:CAN:FORMerror............................................................................................449
TRIGger:A:CAN:TYPE <TriggerType>
Specifies the trigger mode for CAN.
Analyse serieller Busse