Rohde & Schwarz RTB2000 Series - Page 449

Fernsteuerbefehle
R&S
®
RTB2000
449Bedienhandbuch 1333.1611.03 ─ 05
TRIGger:A:CAN:FORMerror <FormError>
Triggers on form errors. A form error occurs when a fixed-form bit field contains one or
more illegal bits.
The command is relevant if TRIGger:A:CAN:TYPE is set to ERRCondition.
Parameter:
<FormError> ON | OFF
*RST: OFF
15.11.5.3 CAN-Decodierungsergebnisse
In allen BUS<b>:CAN...-Befehlen gibt das Suffix <b> den Bus an.
BUS<b>:CAN:FCOunt?.................................................................................................. 449
BUS<b>:CAN:FRAMe<n>:TYPE?....................................................................................449
BUS<b>:CAN:FRAMe<n>:STATus?.................................................................................450
BUS<b>:CAN:FRAMe<n>:STARt?...................................................................................450
BUS<b>:CAN:FRAMe<n>:STOP?................................................................................... 451
BUS<b>:CAN:FRAMe<n>:DATA?....................................................................................451
BUS<b>:CAN:FRAMe<n>:ACKState?..............................................................................451
BUS<b>:CAN:FRAMe<n>:ACKValue?............................................................................. 451
BUS<b>:CAN:FRAMe<n>:CSSTate?............................................................................... 452
BUS<b>:CAN:FRAMe<n>:CSValue?................................................................................452
BUS<b>:CAN:FRAMe<n>:DLCState?.............................................................................. 452
BUS<b>:CAN:FRAMe<n>:DLCValue?..............................................................................453
BUS<b>:CAN:FRAMe<n>:IDSTate?.................................................................................453
BUS<b>:CAN:FRAMe<n>:IDTYpe?................................................................................. 453
BUS<b>:CAN:FRAMe<n>:IDValue?.................................................................................453
BUS<b>:CAN:FRAMe<n>:BSEPosition?.......................................................................... 454
BUS<b>:CAN:FRAMe<n>:BCOunt?.................................................................................454
BUS<b>:CAN:FRAMe<n>:BYTE<o>:STATe?....................................................................454
BUS<b>:CAN:FRAMe<n>:BYTE<o>:VALue?....................................................................455
BUS<b>:CAN:FCOunt?
Returns the number of received frames.
Suffix:
<b>
.
1 | 2
Rückgabewerte:
<FrameCount> Total number of decoded frames.
Verwendung: Nur Abfrage
BUS<b>:CAN:FRAMe<n>:TYPE?
Returns the type of the specified frame.
Analyse serieller Busse