Rohde & Schwarz RTB2000 Series - Page 456

Fernsteuerbefehle
R&S
®
RTB2000
456Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<SearchCondition> FRAMe | ERRor | IDENtifier | IDData | IDERror
FRAMe
Search for a frame type. Set the frame type with SEARch:
PROTocol:CAN:FRAMe.
ERRor
Search for errors of one or more error types. Set the error types
with SEARch:PROTocol:CAN:ACKerror, SEARch:
PROTocol:CAN:BITSterror, SEARch:PROTocol:CAN:
CRCerror and SEARch:PROTocol:CAN:FORMerror.
IDENtifier
Search for identifier.
Specifiy the identifier with SEARch:PROTocol:CAN:FTYPe,
SEARch:PROTocol:CAN:ITYPe, SEARch:PROTocol:CAN:
ICONdition and SEARch:PROTocol:CAN:IDENtifier.
IDData
Search for identifier and data.
Set the identifier (see IDENtifier) and the data with SEARch:
PROTocol:CAN:DLENgth, SEARch:PROTocol:CAN:
DCONdition and SEARch:PROTocol:CAN:DATA.
IDERror
Search for errors that occur with a specified identifier.
Set the identifier (see IDENtifier) and the errors to be found (see
ERRor)
*RST:
FRAM
SEARch:PROTocol:CAN:FRAMe <Frame>
Selects the frame type to be searched for.
The command is relevant if SEARch:PROTocol:CAN:CONDition is set to FRAMe.
Parameter:
<Frame> SOF | EOF | OVERload | ERRor | DTA11 | DTA29 | REM11 |
REM29
SOF: start of frame
EOF: end of frame
OVERload: overload frame
ERRor: error frame
DTA11: data frame with 11bit identifier
DTA29: data frame with 29bit identifier
REM11: remote frame with 11bit identifier
REM29: remote frame with 29bit identifier
*RST: SOF
Analyse serieller Busse