Fernsteuerbefehle
R&S
®
RTB2000
460Bedienhandbuch 1333.1611.03 ─ 05
●
CHANnel<m>:THReshold auf Seite 282
In allen BUS<b>:LIN...-Befehlen gibt das Suffix <b> den Bus an.
BUS<b>:LIN:DATA:SOURce........................................................................................... 460
BUS<b>:LIN:POLarity.....................................................................................................460
BUS<b>:LIN:STANdard.................................................................................................. 460
BUS<b>:LIN:BITRate..................................................................................................... 460
BUS<b>:LIN:DATA:SOURce <Source>
Sets the source of the data line. All channel waveforms can be used.
Suffix:
<b>
.
1 | 2
Parameter:
<Source> CH1 | CH2 | CH3 | CH4 | D0..D15
*RST: CH1
BUS<b>:LIN:POLarity <Polarity>
Defines the idle state of the bus. The idle state is the recessive state and corresponds
to a logic 1.
Suffix:
<b>
.
1 | 2
Parameter:
<Polarity> IDLHigh | IDLLow
IDLHigh: Low active, negative polarity
IDLLow: High active, positive polarity
*RST: IDLL
BUS<b>:LIN:STANdard <Standard>
Selects the version of the LIN standard that is used in the DUT. The setting mainly defi-
nes the checksum version used during decoding.
The most common version is LIN 2.x. For mixed networks, or if the standard is
unknown, set the LIN standard to AUTO.
Suffix:
<b>
.
1 | 2
Parameter:
<Standard> V1X | V2X | J2602 | AUTO
*RST: V1X
BUS<b>:LIN:BITRate <BitRate>
Sets the number of transmitted bits per second.
Analyse serieller Busse
To Next Page
Loading...
