Rohde & Schwarz RTB2000 Series - Parallele Busse

Fernsteuerbefehle
R&S
®
RTB2000
479Bedienhandbuch 1333.1611.03 ─ 05
Rückgabewerte:
<Points> Number of data points in the selected range.
Std.-einheit: Samples
See also: CHANnel<m>:DATA:POINts
15.12.2 Parallele Busse
● Paralleler Bus - Leitungskonfiguration.................................................................. 479
● Parallel getakteter Bus - Konfiguration..................................................................480
● Parallele Busse - Decodierungsergebnisse.......................................................... 481
15.12.2.1 Paralleler Bus - Leitungskonfiguration
BUS<b>:PARallel:WIDTh <BusWidth>
Sets the number of lines to be analyzed for the parallel bus.
Suffix:
<b>
.
1..2
Selects the parallel bus.
Parameter:
<BusWidth> Maximum number is the number of input channels.
Bereich: 1 bis 4
Inkrement: 1
*RST: 4
Std.-einheit: Bit
BUS<b>:CPARallel:WIDTh <BusWidth>
Sets the number of lines to be analyzed for the parallel clocked bus.
Suffix:
<b>
.
1..2
Selects the parallel bus.
Parameter:
<BusWidth> Bereich: 1 bis 15 (clock only) or 14 (clock and CS)
Inkrement: 1
*RST: 4
Std.-einheit: Bit
BUS<b>:PARallel:DATA<m>:SOURce <DataSource>
BUS<b>:CPARallel:DATA<m>:SOURce <DataSource>
Defines the logic channel that is assigned to the selected bit.
Use the command for each bit of the bus.
Mixed-Signal-Option (Option R&S
RTB-B1)