Rohde & Schwarz RTB2000 Series - Page 488

Fernsteuerbefehle
R&S
®
RTB2000
488Bedienhandbuch 1333.1611.03 ─ 05
WGENerator:MODulation:ASK:FREQuency <Frequency>
Sets the frequency of the modulating waveform for ASK modulation.
Parameter:
<Frequency>
WGENerator:MODulation:ASK:DEPTh <ModulationDepth>
Sets the modulation depth, the percentage of the amplitude range that is used for ASK
modulation.
Parameter:
<ModulationDepth>
WGENerator:MODulation:FSK:HFREquency
<HoppingFrequency>
Sets the second frequency of the FSK-modulated signal.
Parameter:
<HoppingFrequency>
WGENerator:MODulation:FSK:RATE <Rate>
Sets the rate at which signal switches between the carrier frequency and the hopping
frequency.
Parameter:
<Rate>
WGENerator:MODulation:RAMP:POLarity <Polarity>
Sets the polarity for the ramp function for a modulation waveform.
Parameter:
<Polarity> POSitive | NEGative
WGENerator:NOISe:ABSolute <AbsoluteNoise>
Sets the noise of the waveform in volts.
Parameter:
<AbsoluteNoise>
WGENerator:NOISe:RELative <RelativeNoise>
Sets the noise of the generated waveform in percentage of the amplitude.
Parameter:
<RelativeNoise>
Signalerzeugung (Option R&S RTB-B6)