Rohde & Schwarz RTB2000 Series - Mustergenerator

Fernsteuerbefehle
R&S
®
RTB2000
490Bedienhandbuch 1333.1611.03 ─ 05
WGENerator:SWEep[:ENABle] <SweepEnable>
Enables or disables sweeping.
Parameter:
<SweepEnable> ON | OFF
15.13.2 Mustergenerator
PGENerator:FUNCtion................................................................................................... 490
PGENerator:PATTern:STATe........................................................................................... 491
PGENerator:PATTern:STIMe........................................................................................... 491
PGENerator:PATTern:PERiod..........................................................................................492
PGENerator:PATTern:FREQuency................................................................................... 492
PGENerator:PATTern:ITIMe............................................................................................ 492
PGENerator:PATTern:BURSt:STATe.................................................................................492
PGENerator:PATTern:BURSt:NCYCle.............................................................................. 492
PGENerator:PATTern:TRIGger:MODE..............................................................................493
PGENerator:PATTern:TRIGger:SINGle.............................................................................493
PGENerator:PATTern:TRIGger:EXTern:SLOPe................................................................. 493
PGENerator:PATTern:ARBitrary:DATA[:SET].....................................................................493
PGENerator:PATTern:ARBitrary:DATA:APPend.................................................................494
PGENerator:PATTern:ARBitrary:DATA:APPend:BOR......................................................... 494
PGENerator:PATTern:ARBitrary:DATA:APPend:BAND....................................................... 494
PGENerator:PATTern:ARBitrary:DATA:APPend:INDex....................................................... 494
PGENerator:PATTern:ARBitrary:DATA:LENGth................................................................. 494
PGENerator:PATTern:COUNter:FREQuency.....................................................................495
PGENerator:PATTern:COUNter:DIRection........................................................................ 495
PGENerator:PATTern:SQUarewave:POLarity....................................................................495
PGENerator:PATTern:SQUarewave:DCYCle.....................................................................495
PGENerator:MANual:STATe<s>.......................................................................................496
PGENerator:FUNCtion <PatternFunction>
Selects the pattern generator function.
Signalerzeugung (Option R&S RTB-B6)