Fernsteuerbefehle
R&S
®
RTB2000
491Bedienhandbuch 1333.1611.03 ─ 05
Parameter:
<PatternFunction> SQUarewave | COUNter | ARBitrary | SPI | I2C | UART | CAN |
LIN | MANual | I2S | TDM
SQUarewave
Square wave function (e.g. for manual probe compensation).
COUNter
Definition of a 4-bit wide counter pattern.
ARBitrary
Definition of a 4-bit wide and 2048 samples deep pattern.
SPI
SPI BUS signals for measurements without measurement
object. Data rate 100 kBit/s, 250 kBit/s or 1 MBit/s.
I2C
I
2
C BUS signals for measurements without measurement object.
Data rate 100 kBit/s, 400 kBit/s, 1 MBit/s or 3.4 MBit/s.
UART
UART BUS signals for measurements without measurement
object. Data rate 9600 Bit/s, 115.2 kBit/s and 1 MBit/s.
CAN
CAN BUS signals for measurements without measurement
object up to 50 MBit/s.
LIN
LIN BUS signals for measurements without measurement object
up to 50 MBit/s.
MANual
Manual pattern mode.
l2S
Audio-I2S BUS signal.
TDM
Audio-TDM BUS signal.
*RST:
SQUarewave
PGENerator:PATTern:STATe <State>
Activates or deactivates the pattern output.
Parameter:
<State> ON | OFF
*RST: ON
PGENerator:PATTern:STIMe <SampleTime>
Sets the time at which each sample is applied for the pattern generator function.
Signalerzeugung (Option R&S
RTB-B6)
To Next Page
Loading...
