Rohde & Schwarz RTE Series - Creating Diagrams (Smartgrid); Display

Remote control commands
R&S
®
RTE
1055User Manual 1326.1032.02 ─ 20
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 18.3, "Programming examples", on page 1054
18.3.1 Display...................................................................................................................... 1055
18.3.1.1 Creating diagrams (SmartGrid)................................................................................. 1055
18.3.1.2 Creating zoom diagrams...........................................................................................1056
18.3.2 Automatic measurements......................................................................................... 1057
18.3.2.1 Performing amplitude/time measurements............................................................... 1057
18.3.2.2 Setting reference levels.............................................................................................1057
18.3.2.3 Waveform histograms............................................................................................... 1058
18.3.2.4 Long-term measurements.........................................................................................1059
18.3.3 Mask testing..............................................................................................................1060
18.3.3.1 Creating a user mask................................................................................................1060
18.3.4 Search.......................................................................................................................1060
18.3.4.1 Searching for a pulse of specified width....................................................................1060
18.3.5 Data management.....................................................................................................1061
18.3.5.1 Saving a screenshot to file........................................................................................1061
18.3.5.2 Exporting waveform data to file.................................................................................1061
18.3.5.3 Exporting measurement results to file.......................................................................1067
18.3.6 Protocol analysis.......................................................................................................1068
18.3.6.1 SENT (option R&S RTE-K10)................................................................................... 1068
18.3.7 Power analysis (option R&S RTE-K31).....................................................................1070
18.3.7.1 Auto deskew..............................................................................................................1070
18.3.7.2 Transient response measurement.............................................................................1071
18.3.1 Display
18.3.1.1 Creating diagrams (SmartGrid)
The example creates 3 diagrams at different positions on the screen, and a zoom dia-
gram. It also minimizes a wavform and adds it to another diagram
Command description in: Chapter 18.7.2.3, "Smartgrid", on page 1094.
Programming examples