Rohde & Schwarz RTE Series - Page 1087

Remote control commands
R&S
®
RTE
1087User Manual 1326.1032.02 ─ 20
DIAGnostic:SERVice:FWVersion?
Returns the firmware version that is currently installed on the instrument.
Return values:
<FirmwareVersion> Version string
Usage: Query only
DIAGnostic:SERVice:COMPutername <ComputerName>
The query returns the computer name that is currently defined. The computer name is
required when configuring a network.
The setting command changes the computer name. The change takes effect after the
next reboot of the computer.
Parameters:
<ComputerName> Name string
DIAGnostic:SERVice:PARTnumber <MaterialNumber>
Returns the material number of your instrument. This number is required to order a
new option, and in case of service.
Parameters:
<MaterialNumber> Number string
DIAGnostic:SERVice:SERialnumber?
Returns the serial number of your instrument. This number is required to order a new
option, and in case of service.
Return values:
<SerialNumber> Number string
Usage: Query only
DIAGnostic:SERVice:CHANnelcount?
Queries the number of available channels.
Return values:
<ChannelCount> Range: 0 to 4
Increment: 1
*RST: 0
Usage: Query only
Firmware/software: V 2.00
Instrument setup