Rohde & Schwarz RTE Series - Page 1100

Remote control commands
R&S
®
RTE
1100User Manual 1326.1032.02 ─ 20
DISPlay:SIGBar[:STATe] <State>
If enabled, the signal bar is displayed.
Parameters:
<State> ON | OFF
Usage: Asynchronous command
DISPlay:SIGBar:POSition <Position>
The signal bar can be placed vertically at the right (default position) or at the left, or
horizontally at the top, bottom or center of the diagram to ensure best visibility of the
waveforms.
Parameters:
<Position> LEFT | RIGHt
Usage: Asynchronous command
DISPlay:SIGBar:HIDE[:AUTO] <AutoHide>
If enabled, the signal bar disappears automatically after some time, similar to the Win-
dows task bar. With the commands DISPlay:SIGBar:HIDE:TIME and DISPlay:
SIGBar:HIDE:TRANsparency, you can define when and how the signal bar hides.
The signal bar reappears if you tap it, or if an action changes the content of the bar.
Parameters:
<AutoHide> ON | OFF
Usage: Asynchronous command
DISPlay:SIGBar:HIDE:TIME <AutoHideTime>
Sets the time when the signal bar is faded out if DISPlay:SIGBar:HIDE[:AUTO] is
"ON".
Parameters:
<AutoHideTime> Range: 0.03 to 86.4E+3
Increment: 0.5
Default unit: s
Usage: Asynchronous command
DISPlay:SIGBar:HIDE:HEAD <HideHeadAlso>
If enabled, the "Auto hide" function hides also the horizontal and trigger label at the top
of the signal bar.
Parameters:
<HideHeadAlso> ON | OFF
Instrument setup