Rohde & Schwarz RTE Series - Page 1104

Remote control commands
R&S
®
RTE
1104User Manual 1326.1032.02 ─ 20
DISPlay:SIGNal:LABel:POSMode <Source>, <PositionMode>
DISPlay:SIGNal:LABel:POSMode? <Source>
Modifies or queries the position mode: either relative to the diagram or with absolute
values according to the units of the waveform. The position mode applies to all labels
of the selected source. For different sources, different position modes can be selected.
Parameters:
<PositionMode> ABS | REL
ABS
Position in time and voltage values, or in other units depending
on the waveform character. Absolute positions move with the
waveform display when the scales, the vertical position or offset,
or the reference point are changed.
Use DISPlay:SIGNal:LABel:HORizontal:ABSolute:
POSition and DISPlay:SIGNal:LABel:HORizontal:
RELative:POSition to set the position.
REL
Fixed label position in percent of the screen counting from the
upper left corner.
Use DISPlay:SIGNal:LABel:HORizontal:RELative:
POSition and DISPlay:SIGNal:LABel:VERTical:
RELative:POSition to set the position.
Parameters for setting and query:
<Source> All waveforms that can be displayed, see DISPlay:SIGNal:
LABel:ADD
Usage: Asynchronous command
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition? <LabelID>, <Source>
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition <LabelID>, <Source>,
<Position>
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition? <LabelID>, <Source>
Modifies or queries the absolute horizontal and vertical positiions of the specified label
if DISPlay:SIGNal:LABel:POSMode is set to ABS.
Parameters:
<Position> Range: Depends on waveform position and scaling
Default unit: s and V, or in other units depending on the wave-
form character
Parameters for setting and query:
<LabelID> String with the label identifier.
<Source> All waveforms that can be displayed, see DISPlay:SIGNal:
LABel:ADD
Instrument setup