Rohde & Schwarz RTE Series - Active Voltage Probes

Remote control commands
R&S
®
RTE
1132User Manual 1326.1032.02 ─ 20
Parameters:
<ManualAttenuation> Range: 100E-6 to 10000
Increment: 0.1
*RST: 1
Default unit: Depends on the selected unit
Usage: Asynchronous command
TRPRobe:SETup:GAIN:MANual <GainManual>
PROBe<m>:SETup:GAIN:MANual <GainManual>
Sets the gain of a current probe.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<GainManual> Range: 100E-6 to 10000
Increment: 100E-6
*RST: 1
Default unit: V/A
Usage: Asynchronous command
18.8.7.4 Active voltage probes
TRPRobe:SETup:CMOFfset..........................................................................................1132
PROBe<m>:SETup:CMOFfset.......................................................................................1132
TRPRobe:SETup:ZAXV................................................................................................ 1133
PROBe<m>:SETup:ZAXV............................................................................................. 1133
TRPRobe:SETup:ACCoupling....................................................................................... 1133
PROBe<m>:SETup:ACCoupling.................................................................................... 1133
PROBe<m>:SETup:ADVanced:PMToffset....................................................................... 1133
PROBe<m>:SETup:ADVanced:RANGe.......................................................................... 1134
TRPRobe:SETup:ADVanced:FILTer................................................................................1134
PROBe<m>:SETup:ADVanced:FILTer............................................................................ 1134
TRPRobe:SETup:ADVanced:AUDioverload.....................................................................1134
PROBe<m>:SETup:ADVanced:AUDioverload................................................................. 1134
TRPRobe:SETup:CMOFfset <CMOffset>
PROBe<m>:SETup:CMOFfset <CMOffset>
Sets the common-mode offset. The setting is only available for differential probes.
Suffix:
<m>
.
1..4
Selects the input channel.
Acquisition and setup