Rohde & Schwarz RTE Series - Page 1221

Remote control commands
R&S
®
RTE
1221User Manual 1326.1032.02 ─ 20
Parameters:
<Source> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 | R2 |
R3 | R4 | TRK1 | TRK2 | TRK3 | TRK4 | TRK5 | TRK6 | TRK7 |
TRK8 | Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 |
Z2V1 | Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4 | DIFF1 |
DIFF2 | COMMON1 | COMMON2
Source of the reference waveform, see Chapter 18.4.2, "Wave-
form parameter", on page 1074
*RST: C1W1
Usage: Asynchronous command
REFCurve<m>:STATe
<State>
If enabled, the reference waveform is displayed in the diagram.
Suffix:
<m>
.
1..4
Reference waveform
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
REFCurve<m>:NAME <Name>
Defines the name of the reference waveform file to be loaded, saved or deleted.
Suffix:
<m>
.
1..4
Reference waveform
Parameters:
<Name> Path and name of the file that contains the reference waveform
or to which the reference waveform is to be stored (.xml
or .bin format), enclosed in single quotes.
Usage: Asynchronous command
REFCurve<m>:OPEN
Loads the reference waveform file selected by REFCurve<m>:NAME on page 1221.
Suffix:
<m>
.
1..4
Reference waveform
Usage: Event
Waveform analysis