Rohde & Schwarz RTE Series - Page 1236

Remote control commands
R&S
®
RTE
1236User Manual 1326.1032.02 ─ 20
WAVeform<m>:XYCurve:RATio <ConstantXYRatio>
If enabled, the x- and y-axes maintain a constant ratio in the diagram.
Suffix:
<m>
.
1..4
XY-diagram
Parameters:
<ConstantXYRatio> ON | OFF
*RST: ON
Usage: Asynchronous command
WAVeform<m>:XYCurve:STATe <State>
Activates an XY-waveform.
Suffix:
<m>
.
1..4
XY-diagram
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
WAVeform<m>:XYCurve:SWAP
Replaces the source of the x-axis with the source of the y-axis and vice versa.
Suffix:
<m>
.
1..4
XY-diagram
Usage: Event
Asynchronous command
LAYout:SIGNal:AXIS <DiagramName>, <Source>, <XSource>
Creates an XY-diagram by adding a second waveform to a diagram.
Setting parameters:
<DiagramName> String with the name of the diagram where the waveform is
added.
Waveform analysis