Rohde & Schwarz RTE Series - Page 1241

Remote control commands
R&S
®
RTE
1241User Manual 1326.1032.02 ─ 20
Firmware/software: FW 3.60
CURSor<m>:USSource <UseSource2>
Enables the second cursor source. To select the second source, use CURSor<m>:
SSOurce on page 1240.
If enabled, the second corsor lines Cx.2 measure on the second source. Using a sec-
ond source, you can measure differences between two channels with cursors.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<UseSource2> ON | OFF
*RST: OFF
Usage: Asynchronous command
Firmware/software: FW 3.60
CURSor<m>:TRACking[:STATe] <TrackCurve>
If set to ON, the horizontal cursor lines follow the waveform.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<TrackCurve> ON | OFF
*RST: OFF
Usage: Asynchronous command
CURSor<m>:X1Position <XPosition1>
Defines the position of the left vertical cursor line.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<XPosition1> Range: 0 to 500
Increment: 0.1
*RST: 0
Default unit: s
Usage: Asynchronous command
Cursor measurements