Rohde & Schwarz RTE Series - Page 1243

Remote control commands
R&S
®
RTE
1243User Manual 1326.1032.02 ─ 20
CURSor<m>:Y2Position <YPosition2>
Defines the position of the upper horizontal cursor line.
If CURSor<m>:TRACking[:STATe] is enabled, the query returns the measurement
result - the upper vertical value of the waveform.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<YPosition2> Range: -50 to 50
Increment: 0.01
*RST: 0
Default unit: The unit depends on the type of the waveform.
Usage: Asynchronous command
CURSor<m>:YCOupling <Coupling>
Defines the positioning mode of the horizontal cursor. If the horizontal cursor lines track
the waveform, the y-coupling is irrelevant (CURSor<m>:MODE TRACk).
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Parameters:
<Coupling> ON | OFF
ON
Moving one cursor line moves the other cursor line too. The cur-
sor lines always remain a fixed distance.
OFF
Each cursor line is positioned independently.
*RST: OFF
Usage: Asynchronous command
CURSor<m>:X1ENvelope <EnvelopeCurve1>
If the waveform arithmetics are set to envelope curve (see CHANnel<m>[:
WAVeform<n>]:ARIThmetics on page 1114) and CURSor<m>:TRACking[:
STATe] is set to "ON", this setting defines how the first horizontal cursor is positioned.
Suffix:
<m>
.
1..*
Selects the cursor set. 2 cursor sets are available.
Parameters:
<EnvelopeCurve1> MIN | MAX
Cursor measurements