Rohde & Schwarz RTE Series - Page 1248

Remote control commands
R&S
®
RTE
1248User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
The suffix is irrelevant.
Usage: Event
Asynchronous command
CURSor<m>:MAXimum[:PEAK]
Sets both cursors to the absolute peak value.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Usage: Event
CURSor<m>:MAXimum:LEFT
Sets cursor 2 to the next maximum to the left of the current position.
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Usage: Event
CURSor<m>:MAXimum:RIGHt
Sets cursor 2 to the next peak to the right (from the current position).
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Usage: Event
CURSor<m>:MAXimum:NEXT
Sets cursor 2 to the next smaller peak (from the current position).
Suffix:
<m>
.
1 | 2
Selects the cursor set.
Usage: Event
CURSor<m>:THReshold <Value>
Defines an absolute threshold as an additional condition for the peak search. Only
peaks that exceed the threshold are detected.
Suffix:
<m>
.
The suffix is irrelevant.
Cursor measurements