Rohde & Schwarz RTE Series - Page 1252

Remote control commands
R&S
®
RTE
1252User Manual 1326.1032.02 ─ 20
Parameters:
<Source> Source of the measurement, see MEASurement<m>:SOURce
on page 1250.
*RST: C1W1
Usage: Asynchronous command
MEASurement<m>:SSRC <Source2>
Defines the second measurement source.
The command is an alternative to MEASurement<m>:SOURce.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<Source2> Second source of the measurement, see MEASurement<m>:
SOURce on page 1250.
Digital channels are only available if a digital channel is set as
first measurement source using MEASurement<m>:FSRC.
*RST: C2W1
Usage: Asynchronous command
MEASurement<m>:CATegory <Category>
Defines the measurement category.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<Category> AMPTime | EYEJitter | SPECtrum | HISTogram | PROTocol
AMPTime
Amplitude and time measurements
EYEJitter
Eye diagram mesurements
SPECtrum
Spectrum measurements
HISTogram
Histogram measurements
PROTocol
Protocol measurements
*RST:
AMPTime
Example: See "Creating and reading histograms" on page 1058
Automatic measurements