Rohde & Schwarz RTE Series - Page 1270

Remote control commands
R&S
®
RTE
1270User Manual 1326.1032.02 ─ 20
<MeasType>
parameter value
(remote control)
Measurement
(manual opera-
tion)
Description/Result Suffix
<n>
SBWidth Bandwidth n dB down bandwidth; the samples to the left and
right of the peak value are analyzed until the n dB
threshold is exceeded; the frequencies at which the
threshold is exceeded define the limits of the
requested bandwidth
4
not used 5, 6
THD THD[dB] Total harmonic distortion in dB 7
THDPCT THD[%] Total harmonic distortion in % 8
THDA THD_a Is equivalent to THD. Requires option R&S RTE-
K18.
9
THDU THD_u Requires option R&S RTE-K18. 10
THDR THD_r Distortion factor. Requires option R&S RTE-K18. 11
PLISt Peak list List of frequency and peak power value pairs.
Requires option R&S RTE-K18.
12
HAR Harmonic search Returns the measured harmonics. For each har-
monic, the frequency and the value are listed. To get
the number of result pairs (= harmonics), use
MEASurement<m>:RESult:COUNt?.
13
THDF THD_f Root mean square of the sum of all amplitudes of
the harmonic waves in relation to the amplitude at
the fundamental frequency (first harmonic).
Requires option R&S RTE-K18.
14
not used 15
MEASurement<m>:SPECtrum:CPOWer:BANDwidth....................................................... 1271
MEASurement<m>:SPECtrum:OBANdwidth................................................................... 1271
MEASurement<m>:SPECtrum:CPOWer:CFRequency.....................................................1271
MEASurement<m>:SPECtrum:NDBDown...................................................................... 1272
MEASurement<m>:SPECtrum:PEXCursion....................................................................1272
MEASurement<m>:SPECtrum:ATHReshold................................................................... 1272
MEASurement<m>:SPECtrum:RESult<n>:COUNt...........................................................1273
MEASurement<m>:SPECtrum:RESult<n>:MODE........................................................... 1273
MEASurement<m>:RESult:MAXCount........................................................................... 1273
MEASurement<m>:RESult:INVerse............................................................................... 1274
MEASurement<m>:RESult:LABorder............................................................................. 1274
MEASurement<m>:RESult:SHFRequency......................................................................1275
MEASurement<m>:RESult:SHLabels.............................................................................1275
MEASurement<m>:SPECtrum:LCHeck<n>:VALid........................................................... 1276
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:LIMit................................................. 1276
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:LIMit.................................................. 1276
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:MARGin............................................ 1277
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:MARGin.............................................1277
Automatic measurements