Rohde & Schwarz RTE Series - Page 1288

Remote control commands
R&S
®
RTE
1288User Manual 1326.1032.02 ─ 20
MEASurement<m>:DISPlay:STYLe <DisplayStyle>
Selects the style in which the measurement waveform is displayed.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<DisplayStyle> LINE | MARKer
LINE
The individual data points are connected by a line.
MARKer
Only the individual data points are displayed as markers.
*RST: LINE
Usage: Asynchronous command
MEASurement<m>:DISPlay:HISTogram <DispHistg>
Displays a histogram for the source of the selected measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<DispHistg> ON | OFF
*RST: OFF
Usage: Asynchronous command
DISPlay:RESultboxes:MEPosition <Position>
Defines the position of the measurement results on the display.
Parameters:
<Position> PREV | FLOA | DOCK
PREV
Preview: result icon on the signal bar
FLOA
Floating: floating result box in front of the diagrams
DOCK
Docked: fixed tab below the diagrams
*RST: DOCK
Usage: Asynchronous command
Automatic measurements